Window tinting can provide lots of benefits in boats. It can keep the boat interior cool by reducing a significant amount of heat gain. It also increases the dock-side privacy as well as the security for both the people inside and their belongings.
Marine window film also provides safety and protection against the danger of glare that the water reflects from the sun as well as from flying shards of glass when the window breaks.
There are lots of types of window films in terms of their construction. They are made with their own configurations which depend on their intended use. One of the types of films that is considered an effective solar protection film is the metallized window film.
What Is Metallized Window Film?
The metallized window film works in keeping the solar heat away from passing through the window by reflecting the heat back to where it came from. This is made through the tiny metallic particles that are embedded into the film.
The metallic content in a metallized window film gives the window glass strength which makes the window system more shatter-resistant. This type of window film gives off a shiny appearance when you look at the outside part, but it is more scratch-resistant than the ordinary dyed film.
How Is a Metallized Film Made?
Metallized films are made through the process of vacuum coating in which metal adheres to the polyester base film. There are also 3 types of the vacuum coating techniques used to make a metallized window film.
Vapor Deposition
Vapor deposition is a process where a certain piece of metal is heated in a tub until it reaches its boiling point and the metal vapor produced is then made to settle into the polyester base film.
The amount of the metal that will settle into the polyester film will depend on the amount of time in which the film passes through the metal vapor chamber.
E-Beam Deposition
E-beam deposition is somewhat similar to the vapor deposition process. However, the metal piece is not heated in a tub but using an electron beam. The advantage of this heating process is that it can process a wider variety of metals.
Sputtering
Sputtering is the newest method of adhering metal into the polyester film. The process of chipping off metal particles from a metal piece involves using electrically charged gas particles in the same chamber used in the deposition process.
Each of these vacuum coating procedures creates higher solar heat control compared to ordinary films. Find your best tinting solution now at WindowTintFL.com.